Searching...
Wednesday, December 21, 2011

cleaning engine airfilter

1. APPLY CLEANER

Liberally spray K&N Air Filter Cleaner onto both sides of filter and allow to soak for 10 minutes to loosen the dirt. Do not allow cleaner to dry on air filter.
 

Panel Air Filter CleaningRound Air Filter CleaningCone Air Filter Cleaning


2. RINSE FILTER
Rinse off air filter with cool low-pressure water applied to the clean side out in order to flush the dirt out of the filter. Continue to rinse the filter until all traces of cleaner are gone. It may be necessary to repeat steps 1 and 2. 

Panel Air Filter RinsingRound Air Filter RinsingCone Air Filter Rinsing


3. DRY FILTER
After rinsing, gently shake off excess water and only allow filter to dry naturally. Do not oil until the filter is completely dry. 

4. OIL FILTER

A.) Squeeze Oil (99-5050)

Apply K&N Air Filter Oil evenly along the crown of each pleat. Allow oil to wick for approximately 20 minutes. Touch up any light areas on either side of filter until there is a uniform red color at all areas. 

Panel Air Filter Squeeze Bottle OilingRound Air Filter Squeeze Bottle OilingCone Air Filter Squeeze Bottle Oiling


B.) Aerosol Oil (99-5000)

Spray K&N Air Filter Oil evenly along the crown of each pleat holding nozzle about 3" away. Allow oil to wick for approximately 20 minutes. Touch up any light areas on either side of the filter until there is a uniform red color at all areas. 

Panel Air Filter Aerosol OilingRound Air Filter Aerosol OilingCone Air Filter Aerosol Oiling


The above process is the only approved procedure for maintaining your K&N Air Filter.

Related articles 




Enhanced by Zemanta

0 comments:

Post a Comment

Popular Posts